10 Efficient Plumbing Tips Every Person Should Know

10 Efficient Plumbing Tips Every Person Should Know
Home Improvement

10 Efficient Plumbing Tips Every Person Should Know

Eventually, most homeowners have to deal with clogged pipes, low water pressure and dripping faucets at some point of time. Being an unskilled, it is obvious that you will hire a professional plumber in London to restore the issue.

Though you don’t have any skill for performing a DIY plumbing task yet necessary tips can help you to face these issues relatively lesser. Know from this blog which they are!

1. Know The Shut-Off Valve Location

While you are about to shift to a new home or installing an all-new plumbing system, know the actual location of the main shut-off valve along with drain. Several times, it has been found that this key switch is located outside of your home.

Moreover, getting acquaintance with certain sewer lines is also essential for you at the time of periodical cleaning. However, condos and apartments don’t have dedicated individual shut-off valves.

2. Never Puncture Pipes

If you are planning to pound nails or drill holes in the walls, ceiling or floor, never attempt the task abruptly as it can cause your pipes behind to leak. This accidental puncture will cost you more to get it repaired.

Hence, you should look for a professional stud finder to get the job done in its appropriate manner. You can also buy an endoscopic camera to perform the DIY task by snaking within the walls.

3. Look Out The Flushable Materials

Homeowners must be aware of the flushable toilets to keep the drainage system normal and efficient in the long run. You shouldn’t flush anything down the drain except toilet papers. Also, flushable baby wipes can lead to nasty clogs which backup it in the future.

4. Never Throw Garbage Down The Drain

Avoid dumping of starchy foods such as potatoes or rice, vegetable peels, bacon grease, food debris and coffee grounds down your kitchen drain. These will certainly block your pipes leading to clogged drain. You are recommended to go through the garbage disposal manual to know the ways to maintain the unit properly.

5. Make Use Of Plunger

You can get a high-quality plunger for the proper eradication of clogs in the drains, sinks and toilets. However, if you have planned for cleaning the sink traps by making most water out with a plunger then, it can be quite messy! But it will create less wet at the same time as you will remove the clogged materials after passing out of water.

6. Take Out The Tacuum Cleaner

Rather using hard and small objects like comb, toothbrush or a kid’s toy for dislodging a clog, you should take out the wet-dry vacuum cleaner. It is a reliable as well as effective devoice for sucking the object out of the drain allowing the water to flow again in its normal speed.

In contrary to plunger, it is far more effective as the plunger pushes the clogged material deep within the drains. As a result, it becomes really tough to remove it.

7. Never Ignore Leaks

The constant dripping issue hikes up the water bill at the end of the month. Even, a leaking faucet wastes 8 gallons of water on a daily basis while that of a running toilet wastes 200 gallons every day. Therefore, you should fix minor leaks by hiring a London good plumber as early as possible before it transforms into a bigger and costlier problem.

8. Don’t Over Tighten The Fittings

Over-tightening of the connections and fittings is the most usual DIY plumbing mistake done by a majority of people. As a result, it leads to the stripped screws and broken bolts. Hence, you should perform the hand-tightening method only for the proper tightening of the fittings.

9. Prefer The Use Of Plumber’s Tape

Also known as Teflon Tape, plumber’s tape can be your ideal companion for sealing the pipe threads perfectly. It will prevent the leaks close to the fittings and joints. Typically, to seal a leak, you have to wrap the tape three times to get the job done perfectly.

Remember, the yellow coloured tape is preferably for gas line connections whereas the white coloured ones is meticulously designed to seal leaks in regular residential plumbing projects.

10. Inspect For The Leaks Regularly

On completion of any plumbing project, you should look out for the leaks with the help of escaping water from the system. You have to open and close the drainage system along with valves for checking so. Sometimes even a professional plumber overlooks the minor leak that needs immediate resealing. Therefore, it is your responsibility to examine the condition of the piping system regularly.

These tips will assure you with the efficiency of the plumbing system in the long run. Even, a lot of money and energy can be saved by taking proper care and maintenance of the entire piping system of your residence. Isn’t that enough!

Back To Top